A specification sheet sells top speed. The number that decides whether you stop before the junction is stopping distance — and it does not scale the way most riders assume. Double your speed and you do not need twice the road. You need roughly four times as much. Change the surface from dry asphalt to wet grass and you need three and a half times as much again.
Those two effects multiply. That is the whole article, and everything below is the arithmetic behind it.
How these numbers were produced
Braking distance, with every wheel braking at the limit of grip, is:
d = v² / (2 · μ · g)
where v is speed in metres per second, g is 9.81 m/s², and μ is the coefficient of friction between tyre and surface. The friction coefficient is the only thing the surface changes — and it changes it a lot.
Two things to be clear about before you read the table. First, the friction values below are typical assumptions, not measurements from an instrumented test. Second, this formula gives the best case — the maximum a scooter could achieve if it used all available grip. A real scooter usually cannot, for reasons covered further down. Treat every figure here as a floor, not a promise. The model assumes a standard braking reaction of 1.0 second for the thinking-distance section.
| Surface | Assumed μ | 20 km/h | 25 km/h | 45 km/h | 55 km/h |
|---|---|---|---|---|---|
| Dry asphalt | 0.70 | 2.2 m | 3.5 m | 11.4 m | 17.0 m |
| Wet asphalt | 0.45 | 3.5 m | 5.5 m | 17.7 m | 26.4 m |
| Dry gravel | 0.40 | 3.9 m | 6.1 m | 19.9 m | 29.7 m |
| Dry grass | 0.30 | 5.2 m | 8.2 m | 26.5 m | 39.7 m |
| Wet grass or mud | 0.20 | 7.9 m | 12.3 m | 39.8 m | 59.5 m |
Braking distance only, modelled 16 November 2026. No reaction time included. Real-world figures vary with tyre condition, pressure, load, temperature and rider technique.
The first law: speed enters squared, not linearly
This is the part that catches people out. Going from 25 km/h to 55 km/h is a 2.2× increase in speed — but a 4.8× increase in braking distance on the same dry asphalt: 3.5 metres becomes 17.0 metres.
From 25 to 45 km/h, a 1.8× speed increase costs 3.2× the distance. The reason is structural: kinetic energy rises with the square of speed, and the brakes have to dispose of all of it. There is no tuning, pad compound or technique that removes that relationship. It is the same reason a car's crash severity climbs so steeply with impact speed.
The practical reading: the faster you go, the less warning you need — you need more. A hazard you would have seen with room to spare at 25 km/h arrives in a quarter of the time at 50 km/h.
The second law: surface is a multiplier, not a nudge
Look down any column of that table. From dry asphalt to wet grass, every figure is exactly 3.5× longer — at 20 km/h, at 25, at 45, at 55. The surface does not add a fixed number of metres. It scales whatever you already had.
That has a consequence that matters more than any single figure: a speed that is comfortable on dry asphalt is a different decision on gravel. 25 km/h needs 3.5 metres on dry asphalt and 12.3 metres on wet grass. You do not get to keep your usual speed and your usual margin; the surface takes one of them.
The third part everyone forgets: the second before you brake
Braking distance starts when the brakes do. Between seeing a hazard and moving your hand, a rider covers ground at full speed. At a 1.0-second reaction — realistic when you are cold, tired, or the hazard appears from a driveway — that is:
| Speed | Thinking distance (1.0 s) | Total stop on dry asphalt | Total stop on wet grass |
|---|---|---|---|
| 20 km/h | 5.6 m | 7.8 m | 13.4 m |
| 25 km/h | 6.9 m | 10.5 m | 19.2 m |
| 45 km/h | 12.5 m | 23.9 m | 52.3 m |
| 55 km/h | 15.3 m | 32.3 m | 74.8 m |
At 55 km/h on wet grass, the distance from spotting a hazard to standing still is 74.8 metres. For comparison, the same scooter at the same speed on dry asphalt stops in 32.3 metres — the wet-grass figure is that plus another 42.5 metres.
Why a scooter usually cannot use all of that grip
The table assumes the tyres are the limit. On most e-scooters they are not, and it is worth knowing why, because it explains the crashes that happen at modest speeds on ordinary roads.
- The rear wheel lifts. A short wheelbase and a high centre of gravity mean hard braking pitches weight forward onto a small front contact patch. Past a certain deceleration the rear tyre is barely loaded, so the front is doing nearly all the work and the total grip available drops.
- Small wheels read the surface differently. A 10-inch tyre meets a pothole edge, a kerb ramp or loose gravel at a sharper angle than a 16-inch wheel. On broken tarmac the effective surface is worse than the smooth sample the friction figure came from.
- Braking is a skill, not a switch. Grabbing a lever produces a locked or juddering wheel and a longer stop than squeezing progressively. Most riders never practise a maximum-effort stop, so the first one happens in an emergency.
- Load moves the numbers. A heavier rider or a loaded backpack changes weight transfer and can lengthen the stop, even though the rated load capacity is unchanged.
In other words: read the table as the best case, then assume your real distance is longer. That is not pessimism — it is how you set a margin.
What to actually do with this
- Set speed by surface, not by habit. When the surface changes — tarmac to gravel, dry to wet — change speed before you enter it, not after. Braking is worst exactly where grip is worst.
- Use the 20 km/h column as your wet-grass reference. 7.9 metres of braking plus 5.6 metres of thinking is still under 14 metres. That is a distance you can judge on sight. 59.5 metres is not.
- Squeeze, do not grab. Progressive pressure on both levers, weight shifted back and low, and let the scooter settle before adding more. Doing this once in an empty car park is worth more than any table.
- Keep the brake system at spec. Pad wear, cable stretch and lever free play all move your stopping distance in the wrong direction, quietly. Our brake adjustment and inspection SOP walks through the check; the climbs and descents guide covers what changes on a gradient, and the wet-weather guide covers rain specifically.
Frequently asked
Is 45 km/h twice as dangerous as 25 km/h?
Not twice — by this model, braking distance is 3.2× longer (3.5 m to 11.4 m on dry asphalt), before you add reaction time. Severity of impact also rises with speed, so the risk compounds beyond the distance alone.
Do disc brakes shorten the distance below these figures?
No. Brakes can only use the grip the tyre has. Better brakes make it easier to reach the limit repeatably and resist fade on long descents — they do not raise the limit itself.
Does a heavier scooter brake worse?
A heavier scooter has more inertia to shed, but if the tyres and geometry can still use the grip, mass cancels out of the equation. What hurts is weight transfer and loading the front beyond what the tyre can hold.
What about tyre pressure?
Under-inflation enlarges the contact patch but deforms the tyre and dulls steering response; over-inflation shrinks it. Check pressures regularly — this is the cheapest change you can make to your stopping distance.
The short version
Speed squares. Surface multiplies. They multiply each other. On dry asphalt at 25 km/h you have 3.5 metres of braking and 6.9 metres of thinking — a gap you can eyeball. At 55 km/h on wet grass the same scooter needs 74.8 metres, which is not a gap anyone eyeballs correctly. Ride to the surface in front of you, and keep the brakes at spec so the numbers stay where they are.
Safety and legal note: the higher speeds referenced here are for private land or closed courses only. Public-road limits for this vehicle class are 20–25 km/h in most EU countries — check your local rules before riding. This article is a physics model for planning margins, not a substitute for rider training or an instrumented brake test.






Condividi:
K2 vs K2 GT: which scooter is right for your riding
The K5: 3000 W, 11-inch tyres, and the one rating that went the other way